Schneider Electric Recommends Precautions for Electrical Safety When Re-Entering Flooded Areas Affected by Irma

ANDOVER, Mass., Sept. 14, 2017 /PRNewswire/ -- Schneider Electric, the global specialist in energy management and automation, urges residents of Southeastern states affected by Hurricane Irma to heed electrical safety precautions to avoid electrocution hazards in the wake of flooding from the storm that has caused millions to lose power.

"Our thoughts are with the people of Southeastern states affected by this devastating storm," said Chad Kennedy, Industry Standards Manager, Power Equipment, Schneider Electric. "As recovery begins, it's extremely important to understand the potential hazards posed by the mix of downed or damaged electrical wires and floodwater. If your neighborhood, building or home is flooded, avoid the area completely until you are positive power has been cut. Failure to do so could be a matter of life and death."

As home and business owners begin to assess the damage and begin the recovery process, they must take necessary precautions, including avoiding flooded areas completely and carefully inspecting their homes and buildings to check whether flooding has taken place before using any electrical system. Typical signs of flooding include standing water, floor and wall stains that indicate flooding, and appliances or electrical equipment that appear to have been exposed to water.

The following precautions are recommended to ensure personal safety, avoid costly damage to physical equipment and minimize the financial losses as residents return:

    --  Do not enter a home or building where there is standing water inside
        until you are sure the main power is off.
    --  If there's evidence of flooding and you're not sure if the main power
        has been turned off, do not attempt to turn it off. Contact an
        electrician or your electric utility.
    --  Locate the main panel to see if any circuit breakers or fuses have
        tripped if there is no electricity upon return.
    --  If there are any signs of smoke, fire or water damage near electrical
        outlets, immediately unplug all items in the area and contact an
        electrician or your electric utility.

For large business owners, Schneider Electric recommends these additional steps:

Wet Electrical Equipment

    --  Electrical equipment that has been exposed to flood waters must be
        inspected by a licensed professional using instructions from the
        manufacturer and industry guidelines.
    --  In general, most electrical equipment exposed to flood water will
        require replacement. There are exceptions to this rule for larger
        equipment, which may be reconditioned by trained factory service
        personnel.
    --  Inspection personnel should contact the equipment manufacturer for
        direct guidance on the equipment evaluation.

Reusing Damaged Electrical Equipment

Attempting to reuse damaged electrical equipment by air drying, rinsing, cleaning, washing down, or pressure washing creates a significant safety hazard. Here's why:

    --  Using abrasives to clean equipment may remove plating or other
        conductive surfaces within the equipment. Also, some compounds in
        cleaning agents can cause deterioration to certain portions of
        electrical equipment.
    --  Contaminants and debris in the flood water can weaken the equipment
        insulation system. These represent potential hazards that may occur upon
        re-energization or even months afterwards.
    --  All electrical equipment should be inspected carefully by a qualified
        electrical contractor to determine whether equipment should be replaced
        or repaired.
    --  Lastly, if there are plans to connect a temporary power source such as a
        portable generator it is imperative that these connections be only
        performed by an electrical contractor. Improper generator connections
        can cause severe injury or death.

In all cases, if there is any doubt about the damage that has been done to a structure and its electrical systems by flooding, contact a local, licensed electrical contractor to evaluate its safety and protect life and property.

For additional information on electrical safety for homes and businesses following Hurricane Irma, visit http://www.schneider-electric.us/en/work/services/water_damaged_electrical_equipment/storm-response-faq/

For additional information for professionals evaluating water-damaged electrical equipment, visit https://www.nema.org/Standards/Pages/Evaluating-Water-Damaged-Electrical-Equipment.aspx#download

About Schneider Electric
Schneider Electric is the global specialist in energy management and automation. With revenues of $26 billion US dollars (25 billion euros) in FY2016, our 144,000+ employees serve customers in over 100 countries, helping them to manage their energy and process in ways that are safe, reliable, efficient and sustainable. From the simplest of switches to complex operational systems, our technology, software and services improve the way our customers manage and automate their operations. Our connected technologies reshape industries, transform cities and enrich lives. At Schneider Electric, we call this Life Is On.

www.schneider-electric.com

Discover Life is On

Follow us on:

https://mobile.twitter.com/SchneiderElec
https://www.facebook.com/SchneiderElectric?brandloc=DISABLE
https://www.linkedin.com/company/schneider-electric
https://plus.google.com/+schneiderelectric/post
https://www.youtube.com/user/SchneiderCorporate
http://tv.schneider-electric.com/site/schneidertv/
http://blog.schneider-electric.com/

Hashtags: #IrmaStorm #GulfCoast

View original content:http://www.prnewswire.com/news-releases/schneider-electric-recommends-precautions-for-electrical-safety-when-re-entering-flooded-areas-affected-by-irma-300519811.html

SOURCE Schneider Electric